Heating advice

Why is my underfloor heating not getting warm?

Wet underfloor heating can underperform because a zone is not calling for heat, an actuator or control is not responding, flow rates are incorrect, air is trapped in a loop or the manifold is not receiving the expected temperature and circulation. The pattern of which zones work is often the best starting point for diagnosis.

Gas Safe Register

Gas Safe registeredRegistration 633795

Heating engineer checking underfloor heating manifold controls
Practical guideUnderfloor heating problems

Quick answer

Why is my underfloor heating not getting warm?

Wet underfloor heating can underperform because a zone is not calling for heat, an actuator or control is not responding, flow rates are incorrect, air is trapped in a loop or the manifold is not receiving the expected temperature and circulation. The pattern of which zones work is often the best starting point for diagnosis.

Possible causes

What could be behind it?

Symptoms can overlap, so this is a starting point rather than a remote diagnosis.

01A thermostat or zone not calling for heat
02Actuator or wiring-centre problems
03Incorrect manifold flow rates
04Air, circulation or heat-source issues

Before you call

Safe checks worth making

Keep the checks simple. Do not remove sealed covers, alter gas components or carry out electrical or refrigerant work yourself.

  1. 01

    Check which zones are affected

  2. 02

    Confirm thermostats are on and set above room temperature

  3. 03

    Look for obvious warning lights or control errors

  4. 04

    Note whether the manifold flow meters show movement

When to get help

Know when to stop checking and get it diagnosed

Arrange a diagnosis when one or more zones stay cold despite correct settings, the manifold shows no flow, or the problem keeps returning.

Explore the underfloor heating service

Local support

Need help in South East London?

These guides support the diagnosis, but the actual system and property still matter. Check the main coverage areas below.

Useful to know

Related questions

Clear answers without pretending every system behaves the same way.

Why is only one underfloor-heating zone cold?

A single cold zone can point toward its thermostat, actuator, loop flow or local control rather than the whole heating system.

Should all manifold flow meters show the same reading?

Not necessarily. Required flow can vary by loop and system design, so settings should not be changed blindly.

Speak to a local engineer

Still not sure what the system is doing?

Call with your postcode and a quick description of the problem. You will get a clear, practical next step.

CallWhatsApp